The Ready Ranger™ is a magnetic landing pad that keeps your rangefinder (or phone) always at the ready. It is part of the Ultimate Tree Gear Collection by JAKT GEAR named Best New Accessory at the 2024 Archery Trade Association Show. It comes with an adhesive-backed steel plate that mounts to the side of your rangefinder (or the back of your phone) and magnetically pairs with the Ready Ranger to secure your electronic device when not in use. The super-strong neodymium magnet is encased in a nylon webbing pouch that contains a neoprene padding layer to keep everything silent when connecting to your device.

Ready Ranger has multiple attachment accessories to enable attachment to any vertical or horizontal webbing on your gear. A shoulder strap webbing adapter (sold separately) is available for gear not equipped with factory-installed shoulder webbing.

A Better Tether™ adjustable-length tether system is included to protect you from dropping your expensive electronics.

For rangefinders:

Mount it to your shoulder strap to quickly and quietly range your target with minimal motion and no fumbling to remove it from and re-insert it back into a pouch/pocket.

(Ready Ranger has the hardware to mount your rangefinder directly to the 1" webbing on your shoulder strap. Our Shoulder Strap Webbing Adapter enables you to mount a Ready Ranger to any shoulder strap not equipped with 1" webbing.)

For phones:

Keep your phone easily accessible and never worry about dropping it from a tree again (A phone tether connector to insert between your phone and case is included)

Attach it to your:

Tree Toolbelt™ - Gear Organizer Strap
Treestand safety harness
Tree saddle suspenders
Backpack shoulder strap
Bino harness/pack
Tactical vest

The UTG Collection is comprised of five products: Tree Toolbelt, Quiver Caddy, Ready Ranger, Better Tethers, and Tactical Gear Clips. Each can be purchased individually, or you can save $25.80 when you buy the complete Ultimate Tree Gear Collection Bowhunter Bundle.

Ready Ranger Installation Instructions:

The adhesive tabs provided with the Ready Ranger steel plate have been specially formulated to bond with silicone and other surfaces typically used on rangefinders, phones, and phone cases. You must allow the plate to cure for a minimum of 24 hours after application or it will not properly adhere to silicone surfaces.

Metal Plate Mounting Instructions:

Select the exact location for mounting the metal plate onto your device. (Mounting location must be flat.)
Clean surface with included alcohol prep pad and allow to dry
Peel backing from adhesive pad on metal plate and press plate into place
Position a heavy book or other similar object to apply constant pressure onto metal plate and allow adhesive to cure for 24 hours prior to use.

Changing Connection Loops on Ready Ranger:

Open hook and loop flap
Remove magnet assembly from pouch
Fold in flaps on connection loop and pull loop from behind the strap on the back of the Ready Ranger pouch
Insert desired connection loop behind the pouch strap and lock into place with the flaps
Hold neoprene sound pad with your thumb and slide magnet back into pouch. (Be sure the four magnets are facing the front of the pouch and the solid steel plate is facing the rear.)
Position the neoprene pad over the top of the magnet assembly and close the flap